Tile cleaning
Our 6 Step Tile and Grout Cleaning Process
1. Pre-treat tile and grout
a. Alkaline based degreasing solution is mopped on
b. Cleaner is allowed to dwell for up to 20 minutes
c. This loosens accumulated soil, grease, contaminants and topical residues
2. Power scrub surfaces
a. Special surrogated brushes agitate the grout lines as well as the tile surface
b. Edge Cleaning and baseboard cleaning are done at this time
3. Turbo rinse
a. Tile and grout is rinsed using pressure heated water
b. All water, cleaning solutions and contaminants are captured and extracted away in one process.
c. System is completely fluid controlled with no over wetting of any other surfaces or areas
4. Repeat process (Steps 1, 2 and 3 above)
a. Above process is repeated now using a low Ph Restorative cleaner
b. Solution works on staining, discoloration, grout haze, soap scum
5. Speed dry/inspection
a. Remove any remaining water on floor
b. Place high powered air movers to dry tile and grout lines
c. Inspect surface for any staining. Spot clean any stains found
6. Grout Preservation System
a. Pigmented grout sealer is applies
b. Creates a water proof barrier to prevent future stain
c. Makes routine maintenance easier
d. Comes with a 5 years warranty
